SilentHomeHub is reader-supported. When you buy through links on our site, we may earn an affiliate commission. Learn more

Need to Stop Slamming Doors? – Device Options for Less Noise

Need to Stop Slamming Doors

Home is a sanctuary, and as much as possible, we want peace and quiet in our personal space.

And we can’t have that if your DOORS SLAM SHUT. Even when no one is near the doors, they can slam shut because of the wind.

Not only is it distracting and annoying, but it’s also a safety hazard — especially if you have little toddlers with you who love to play around with doors.

In this guide, we’ll show you the different methods you can do to stop a door from slamming shut.

Table of Contents

How to Prevent Door From Slamming Loudly

There are different ways you can stop a door from slamming WITHOUT HAVING TO REPLACE IT.

The following methods we’ll mention involve different products. Some you can permanently attach, and some you can temporarily stick to the door frame.

And if you’re not up for complicated installation processes, we also provided some simple DIY METHODS! It’s time to pick up one of these clever devices to prevent your door from slamming once and for all!

#1 First Things First, Check the Door Hinges!

Before you start looking for products you can use, CHECK YOUR DOOR HINGES FIRST!

Door hinges get worn out over time which causes them to slam.

Sometimes, it’s the hinge screws that are improperly mounted. This causes a slight imbalance that results in slamming.

To see if the hinges are properly screwed:

  1. You can check this by opening the door, 90-degrees wide.
  2. Use a leveling tool to see if it’s balanced or not.
  3. Reinstalling and tightening up the screws can solve this problem in a jiffy!

But if the hinges themselves are worn out, you might need to change them. You can choose to do this on your own, or you could hire a professional to keep it neat.

We recommend getting Rounded 3.5 Inch x 3.5 Inch Door Hinges from Amazon.

To replace your door hinges, you don’t need to remove the entire door. You can replace them one at a time:

  1. Unscrew the top hinge first, starting with the side attached to the door.
  2. Replace it with the new hinge and screw the anchor screws tight. Use a level to see if it’s balanced.
  3. Do the same with the other two hinges. Make sure to check the alignment!

If installed properly, it should stop a door from slamming.

#2 Invest and Install an Automatic Door Closer

Installing an automatic door closer, like the Dakason Automatic Door Closer, may be a bit pricey, but it’s A WORTHY INVESTMENT.

You’ll see an automatic door closer in many commercial establishments for one reason: to prevent doors slamming shut loudly because of the wind.

The door closer is attached to a door edge and door frame and STOPS A DOOR from slamming with its air pressure-filled piston. It also makes it easy to install a door in general.

There are two types of door closer products:

  • Wrights Product V920WH – easy-to-install door closer for home use
  • Hydraulic Door Closer – used for commercial and industrial establishments.

Make sure to get a door closer product that has adjustable pressure changes and door speed:

  • After letting go of an open door, a higher air pressure setting will automatically slow it down and close it.
  • You should be able to determine the door speed at the last ten degrees of closing.

The installation process should be a breeze if you follow the product instructions.

Just remember to choose a door closer that’s made of STEEL OR ALUMINUM for more durability.

#3 Want a Simpler Alternative? Check Out These Anti-Door Slam Products

If you’re not up to doing all that manual labor, you can resort to using these different anti-door slam products.

These items are pretty SIMPLE AND QUICK remedies to keep doors from slamming shut.

Pinch Guards

IF YOU HAVE KIDS AT HOME, finger pinch guards are one of the best ways to keep a door from slamming your child’s fingers.

Here’s what you need to know about door pinch guards:

  • The pinch guard works as a doorstop.
  • Pinch guards have a C-shape foam structure that you slide on the side of the door.
  • Its installation process is pretty simple! Just place the pinch guard on top of the door, at least six inches from the outer edge.
  • You can also choose to place pinch guards above the handle, over the hinges, or anywhere along the door edge.
  • When not in use, you can just hang it on the door handle.
  • It stops the door slamming by providing a soft cushion between the door and the door frame.
  • It’s not a permanent anti-door slam product, and you have to remove it when you’re closing the door.

You don’t need to attach more than one per door, but it does get worn out over time.

This is a must-have for someone who has playful kids!

Whether the door slamming is caused by kids playing, or strong wind from outside, it’s a great way to stop a door from slamming shut.

We recommend getting the Wittle Finger Pinch Guard Foam Door Stopper.

Door Cushion

What we recommend: Original Cushy Closer Door Cushion

A door cushion covers the latch bolt of the door. It doesn’t prevent it from closing, but it does serve as a thin barrier.

Good enough to stop a door from slamming!

Here’s what you need to know about the door cushion:

  • This product was made to prevent the door from making any noise if you have any kids sleeping in a room.
  • It also prevents a door from getting locked.
  • Parents can also use this to keep their children from accidentally getting locked inside a room.

To install it, just hook the elastics to the door knobs on either side of the door.

Dreambaby Stop Slam

This Dreambaby product works like the pinch guard.

The only difference is, it’s to be screwed PERMANENTLY on top of the door frame.

There are mixed reviews from different people on its effectiveness. Some say the product does nothing, but it’s mostly because of improper installation.

If it’s properly screwed in, it will effectively stop a door from slamming.

You can get the Dreambaby Stop Slam on Amazon.

#4 Prevent the Door From Making Noise With a Door Silencer

What we recommend: Rockwood 608 DuraFlex Rubber Door Silencer

This door silencer is usually used on heavy steel doors inside hospitals and schools. But it works just as fine with wooden doors!

It’s made out of heavy-duty rubber that can quickly solve the door slamming problem and prevent the door from making noise.

This thing is pretty easy to install, too, making it perfect for your home. Just be sure you also have a door stop section.

Here’s how to install a door silencer:

  1. Drill a 1/4″ hole into the doorstop section of the door frame.
  2. The hole is made for the rubber cone to slip inside without falling out.
  3. The 1/8″ flat section of the cone will be placed along the door stop section and act as a shock absorber.

The door silencer is FLEXIBLE enough for the door to close without being slam shut.

#5 Slip in Some Door Seals!

What we recommend: Frost King DS2 Door or Window Draft Stop Cloth Seal

Door seals were initially made to cover door gaps and prevent drafts from entering a room. Besides its original purpose, it can also work as a remedy for the door slamming problem.

Door seals add more resistance against the floor, preventing the door from slamming shut.

#6 Looking for a Quick Fix? Use a Rubber Band!

One of the QUICKEST AND MOST ACCESSIBLE things you can do to prevent the door from slamming is to use a thick rubber band.

Here’s how to use the rubber band as a door silencer:

  1. Just hook the rubber band on a door handle
  2. Stretch it above and below the latch
  3. It should cover a portion of the side of the door.

The rubber band should act like a bumper that creates a barrier between the door itself and the frame.

#7 Need a Cheap Method? Use Felt Pads!

If you’re looking for another cheap solution to prevent the door from slamming, using FELT PADS is one of the best ways to go!

You can purchase some self-adhesive felt pads online and just stick them along the edge of the door frame.

The felt pads will act as little cushions that will keep the door from slamming.

#8 Work Around With a Weather Stripping Kit

Weather-stripping kit we recommend: KELIIYO Door Weather Stripping Seal Strip for Doors and Windows

Using weather-strip tape or weather strips is another one of the best CHEAPEST solutions for a slamming door!

People usually use this for soundproofing doors and windows.

Here’s how to set up your weather strips:

  1. Clean the door frame’s inside surface and measure the gap between it and the door.
  2. Cut the weather strip to its required length.
  3. Since it’s self-adhesive, just peel it and stick it carefully along the frame.

One thing you need to make sure of is that it shouldn’t have any gaps!

#9 If You Need Something Smaller, Use a Door Bumper!

What we recommend: GorillaGrit Door Stopper Wall Protector

Doors tend to slam against walls too! Constantly doing so will create dents and scratches on your wall paint.

These rubber door bumpers are a pretty CHEAP FIX!

Just pinpoint the part where the door knob often hits the wall and stick the bumper in there.

If you’re someone who’s very conscious of the color, feel free to paint over them to match your wall!

#10 Feeling Crafty? Do a DIY Door Slam Preventer!

If you’re not keen on buying stuff to solve the slamming door, you could always have a DIY project for it instead!

DIY Draft Stopper

You can make your own draft stoppers out of pieces of old clothing.

Here’s how you can make your own draft stopper:

  1. Measure the width of your door.
  2. Get your old pieces of clothing and them according to how wide the foot of your door is.
  3. You can choose to either sew or glue the cloth together for them to look like long tube pillowcases.
  4. You can fill them up with rice or any type of stuffing and sew it shut.
  5. Put it under the door, and it’ll act like a door seal. It should add resistance whenever you close the door.

Fabric Slam Guard

With old clothing fabric again, you can sew your own temporary slam guard.

Here’s how you can make one:

  1. Cut your cloth and make two small fabric rectangles. They should be large enough to cover the door latch.
  2. Sew the three sides and stuff it with cotton. It should be thick enough to cover the door gap.
  3. Sew it shut and add elastic loops on the two sides. Make sure the elastics are secure.

Once you’ve made your own slamming guard, hook it on the two door knobs. It should cover the latch of the door and prevent loud slams.

Foam Door Slam Stopper

This is the EASIEST DIY out of the three.

Here’s how you can make your own foam stopper:

  1. Grab some old foam puzzle pieces or any type of firm foam (an acoustic foam or a sponge can work, too!).
  2. Cut a 2-3 inch circle out of it.
  3. Cut a smaller circle inside and make a donut shape. It should be as wide as your door.
  4. Cut one side for it to be a tight “C” shape.

Slide it on the side of your door. And voila! You have your foam guard!

Why Is It Important to Stop a Door From Slamming Shut

It’s very important to take these childproof precautions if you have a child at home. You don’t want a door to slam in their face!

  • Most of the time, toddlers play around with doors.
  • If unsupervised, their fingers can get caught upon the door closing.

Besides the startling noise it creates, frequent slams can damage your door and your wall.

  • DOOR JAMB: A ruptured jamb causes the hinges to pop out of alignment and creates an imbalance in your door.
  • WALL: The impact can chip off the paint on your wall, creating that ugly smudge over it.

Wrapping It All Up!

There are a lot of ways to prevent your door from startling you with a SLAM!

But you should always START BY CHECKING ITS HINGES. Usually, all it takes is some screw tightening, and you’re good to go!

You could also install the ANTI-DOOR SLAM PRODUCTS we mentioned above. They’re great ways to soundproof your door from any sudden noises.

And if you’re not up to spend a lot of bucks, there are CHEAPER OPTIONS like the rubber bands and felt pads.

Or you could do the DIY PROJECTS provided!

We hope this article provided enough options for you to prevent door slams. You now have all the tips, tricks, and knowledge to stop a door and keep it from that SLAM!


Changelog:

July 8, 2021 – removed affiliate links, updated external links

June 30, 2021 – added changelog, updated title and featured image, fixed article format, updated internal linking, optimized content

About the Author

andrea_adams

Andrea has always been bombarded by the hustle and bustle outside her home. Living in the city doesn’t get any quieter. The never ending noise from construction, traffic, and dogs barking on the streets day in and day out drove Andrea to a breaking point.

For 3 years, Andrea committed herself to studying DIY hacks, performing soundproofing experiments, and installing noise-free solutions. Now, she lives a quiet life free of the stress from noisy environments.

She hopes to share this knowledge so that others don’t have to endure the noise reigning in their ears and live a peaceful, stress-free life.